Originally Posted by Jauly ➡️

Fist I wanna say that it was an UI crime not to label A and B under the Morph knob... every time the manual mentioned Layer A and B I was searching the whole panel where the heck the buttons for them were lol.

Now my question: How do I easily detune both layers to each other without fiddling every time deep into the oscillator settings?

Originally Posted by Jauly ➡️

Fist I wanna say that it was an UI crime not to label A and B under the Morph knob... every time the manual mentioned Layer A and B I was searching the whole panel where the heck the buttons for them were lol.

Now my question: How do I easily detune both layers to each other without fiddling every time deep into the oscillator settings?

Originally Posted by Pip ➡️

Love my PB but I would like to see more master options as well, that defaults to all presets, a master layer if you like - analogue accuracy would be one on my list

Originally Posted by discombob ➡️

Merry synthmas, everyone. I have been thinking for a while now about how to share our own presets as a community in a centralized location, but haven't found anything ideal yet other than just the attachments here, so...

In the spirit of the old web where people still freely shared and collaborated with each other, please enjoy my PolyBrute bank called "Elektro-Lux". I strived to make most of these patches very interactive even on the original PB6 controls, since expression is a real strength here.

I hope it encourages people to share some of theirs as well; I can always enjoy exploring a new configuration on this beast

Originally Posted by Marzzz ➡️

So I had bought my Polybrute 12 the end of last September, and as I noted previously even when it was on for hours I never noticed any significant heat coming from the vents; I even commented at how well it was engineered. This evening I had my synths on for a few hours, and was actually mostly playing/programming my 3rd Wave. During the session I did notice a "warm electronic smell" and for the first time ever I felt heat coming out of the PolyBrute's vents, and the back end of the case was quite warm (but not hot) to the touch. Nothing has otherwise changed from previous, and the synth plays normally. Next time I will check the temperature (I have one of those laser thermometer guns). Curious...

Originally Posted by exdc ➡️

Did you ever measure the PB12 heat with your laser?