SPX90 output level? - Gearspace.com
The No.1 Website for Pro Audio
SPX90 output level?
Old 6th July 2005
Gear Maniac
๐ŸŽง 15 years
SPX90 output level?

Do I need to run the outs through preamp before going to converters(Lynx or Mytek)? Don't seem to be getting much level going direct.
Old 7th July 2005
Lives for gear
๐ŸŽง 15 years
Preamp shouldn't be needed.

Check the input and output level switches - if the output is -20 db, try the +4 setting, and you should have tons of drive. If the input is set to +4, and you're running it with a -10 db input, you also might find the levels low.

Old 7th July 2005 | Show parent
Lives for gear
MJGreene Audio's Avatar
๐ŸŽง 15 years
Also make sure that your running a true unbalanced input and output. If I remember correctly when I hooked up a TRS cable the output was much lower than when it was just a Tip Sleeve connector. I just made up a bunch of balanced to unbalanced connectors and it worked much better.

Its been years since I hooked mine up so I could also be totally nuts.
Michael Greene
Old 7th July 2005 | Show parent
Gear Maniac
๐ŸŽง 15 years
The output is on the +4 and still very little output. ..and there's plenty of signal on the input meter. Tried it through my ISA 428 and got lots of gain.......but like you say it doesn't seem like I should have to.
๐Ÿ“ Reply

Similar Threads

Thread / Thread Starter Replies / Views Last Post
replies: 97 views: 26269
Avatar for Grazi
Grazi 30th December 2016
replies: 336 views: 166449
Avatar for mr drummer
mr drummer 10th May 2016
Post Reply

Welcome to the Gearspace Pro Audio Community!

Registration benefits include:
  • The ability to reply to and create new discussions
  • Access to members-only giveaways & competitions
  • Interact with VIP industry experts in our guest Q&As
  • Access to members-only sub forum discussions
  • Access to members-only Chat Room
  • Get INSTANT ACCESS to the world's best private pro audio Classifieds for only USD $20/year
  • Promote your eBay auctions and Reverb.com listings for free
  • Remove this message!
You need an account to post a reply. Create a username and password below and an account will be created and your post entered.

Slide to join now Processing…

Forum Jump
Forum Jump