View Single Post
Old 1st August 2021 | Show parent
Lives for gear
Originally Posted by jamesmafyew ➡️
SRS now has a 45cm A-B bar for the OM1:

It requires some user assembly, since the finished product was apparently a little too large for the bed of the 3d printer.
That’s great if 45cm is a frequently optimal AB spacing for you…what I’d like to see is an adjustable SRS bar using a pair of sliding cylindrical shaft elements, one for each side (one telescoping inside another), with a locking clamp to hold the extensions in place. 38-68 cms width variability would be sufficient…

Last edited by studer58; 1st August 2021 at 03:49 AM..