Quote:
Originally Posted by
mattiasnyc
➡️
Check the official forum. There seems to have been recent changes to this so that the MCU device now follows channel show/hide.... if that's what you mean.... or did you mean specifically not that but 'selection'....?
No. What I mean is more basic. I don't use show/hide very much because I'm using 4 linked video monitors.
Example: in Cubase click on fader 1 to make sure it has focus. Then on the QconPro touch for example...fader 15. (of course you will have to shift banks on the QconPro.) Observe that Cubase fader 15 is now highlighted. Cubase follows the QconPro. This is correct behavior.
But the other way around it doesn't work. Click on fader 1 in Cubase to make sure it has focus. Then on Cubase click on fader 15 so it has focus. Note on the Qcon that you must now manually shift (bank shift) to see that fader 15 on the QconPro is highlighted.
Apologies for not making this clear. It is the bank shifting on the QconPro that doesn't work. The highlighted channel actually works on QconPro but you have to manually shift banks to find that channel 15 highlighted on the QconPro. Bank shifting should be automatic so it follows the channel focused on Cubase.