Hey everyone,

I've been using Nugen Stereoizer and bx_stereomaker and comparing the two. I'm making mixes kind of similar to Kygo where the sound is very wide.

The bx_stereomaker has a feature that shows you when you're going "out of phase." If you start trying to spread the stereo too much, it will show you the correlation meter goes red and then your signal is negative/out of phase.

However, Nugen Stereoizer does not have this. How do we know if the signal Nugen is producing is out of phase?

Do we have to be careful with Nugen, or else we may be making our tracks out of phase? Or did Nugen perhaps add a failsafe where it prevents the output from being out of phase?

Just wondering about this and I don't really know anyone else using these plugins!